5 Camera Setting and Adjustment
35
UHL-43 2005 VER1 (E)
5.3 Creation of a lens file
7KHSXUSRVHRIFUHDWLQJDOHQV¿OHLVWRPHPRUL]HWKHFRORU
balance change resulting from the lens' optical characteristics.
In that way, it optimizes GAIN, Flare, and W.SHADING
ZKHQOHQVHVZLWKGLIIHUHQWPDJQL¿FDWLRQRUPDQXIDFWXUHU
DUHXVHGRUZKHQWKHH[WHQGHULVFKDQJHG7KHOHQV¿OHLV
switched by selecting the lens number with the menu. It is
not necessary to readjust every time. Lenses supporting
VHULDOGLJLWDOLQWHUIDFHFDQUHFDOOWKHDSSURSULDWHOHQV¿OH
automatically. In addition, the extender status is memorized.
Thus, automatic switching is possible by the extender answer
signal from the lens.
8SWROHQVHVFDQEHUHJLVWHUHGSHUFDPHUDVR¿OHVFDQDOVR
EHFUHDWHGZKHQDSURPSWHURUDQH[WHUQDO¿OWHULVXVHG
Ŷ
Constructing the environment
Construct the test environment as shown in the following
¿JXUH
At the start, attach the "standard lens" to be used for the basic
setup of the camera. In addition, use a uniform white chart as
the subject. Adjust the light using a light meter so the entire
chart has uniform brightness.
Memo
:KHQFUHDWLQJDOHQV¿OHVHWWKHRSWLFDO¿OWHUWR1'
&/($5DQGWKH&&¿OWHUWR.,QDGGLWLRQ
PDNHVXUHWKDWDVSHFLDOHIIHFW¿OWHULVQRWDWWDFKHGWRWKH
IURQWVHFWLRQRIWKHOHQVRUWRWKHLQWHJUDWHG¿OWHUGLVF,I
DVSHFLDO¿OWHULVDWWDFKHGWKHUHDUHFDVHVWKDWWKHOHQV¿OH
cannot be created correctly.
:KHQFUHDWLQJWKHOHQV¿OHVWKRURXJKO\SUHSDUHDOOWDUJHW
OHQVHVDQGFUHDWHWKH¿OHVVHTXHQWLDOO\ZLWKRXWLQWHUUXSWLRQ
under the same conditions. When the conditions change
GXULQJ¿OHFUHDWLRQDFFXUDWHVHWWLQJEHFRPHVLPSRVVLEOH
7KHOHQV¿OHLVXVHGWRPHPRUL]HWKHOHYHOGLIIHUHQFH
between lenses. Therefore, if the light or the chart changes,
it cannot be judged whether the difference is due to the
lens, light, or chart.
WFM
Coax cable
Chart on which Kent paper, etc. has been pasted
and the entire surface is a uniform white.
Light
Light
Camera
Picture monitor
(connect if required)
Illumination
meter
SDI OUT connector
