IFM CR711S, Оригинальное руководство по программированию

Страница: 127 / 205

127
ifm Programming Manual ecomatController/60-1 (CR711S) Operating System V2.5.0.n 2017-12-19
ifm function libraries Library ifmIOcommon.library
>
Diagnostic codes (
→ Messages / diagnostic codes of the function blocks
(
→ p.
180 )):

ERR_INVALID_VALUE Error: at least 1 invalid input parameter or invalid combination of input parameters;
Function call has been stopped.

ERR_INTERNAL Error: Internal system error
► Contact the ifm Service Center!

ERR_UNDEFINED Error: Unknown error
► Contact the ifm Service Center!

ERR_SHORT_CIRCUIT Error: Short circuit with GND or VBBx.

ERR_OPEN_CIRCUIT Error: Open circuit detected. Possible cause: Wire break.

ERR_OVERLOAD_CURRENT Error: Maximum current exceeded.

ERR_STUCK_AT Error: Signal is frozen.

ERR_STUCK_AT_HIGH Error: Signal frozen, signal state high.

ERR_STUCK_AT_LOW Error: Signal frozen, signal state low.

ERR_OVERVOLTAGE Error: Maximum signal voltage exceeded.

ERR_UNDERVOLTAGE Error: Minimum signal voltage not reached.

ERR_UNDERVOLTAGE_VBBX

For inputs: Error: Reference voltage not reached.

For outputs. Error: The voltage of the corresponding output group supply or at
VBB30 / VBB15 is not reached.

ERR_OVERVOLTAGE_VBBX

For inputs: Error: Reference voltage exceeded.

For outputs. Error: Voltage of the corresponding output groups supply or at VBB30
/ VBB15 not reached.

DIAG_INVALID_VALUE At least one input parameter is invalid or exceeds the permissible area.

DIAG_INTERNAL Internal system error.

DIAG_OPEN_CIRCUIT Open circuit detected. Possible cause: Wire break.

DIAG_SHORT_CIRCUIT Error: Short circuit with GND or VBBx.

DIAG_UNDERVOLTAGE_VBBX

For inputs: Error: Reference voltage not reached.

For outputs. Error: The voltage of the corresponding output group supply or at
VBB30 / VBB15 is not reached.

DIAG_OVERVOLTAGE_VBBX

For inputs: Error: Reference voltage exceeded.

For outputs. Error: Voltage of the corresponding output groups supply or at VBB30
/ VBB15 not reached.

DIAG_OVERLOAD_CURRENT Maximum current exceeded.

DIAG_STUCK_AT Error: Signal is frozen.

DIAG_STUCK_AT_HIGH Error: Signal frozen, signal state high.

DIAG_STUCK_AT_LOW Error: Signal frozen, signal state low.

DIAG_OVERVOLTAGE Maximum signal voltage exceeded.

DIAG_UNDERVOLTAGE Error: Minimum signal voltage not reached.

DIAG_NO_CALIB The selected resource has no valid calibration.
The displayed values are maybe faulty.

DIAG_ACCESS FB/Function cannot access the required resource; Resource is blocked by another task.

DIAG_CHANGEOVER_TIME Minimum changeover time for the highside-lowside selection of the drivers has not yet
expired.
>