IEMCA BOSS 338 HD, Руководство по эксплуатации и техническому обслуживанию

Страница: 127 / 214

6 - USE AND OPERATION Boss 338HD - 552HD
EN
6 - Pag. 7 / 7
13 Selects the keyboard modes:
- with LED off ; selects the "message
display" mode.
- with LED on ; selects the "parameter
display" mode.
14 Multifunction
- Selects the next parameter
- Moves the selection cursor rightwards.
15 Selects the feeding of a new bar until the facing
position is reached.
- Press both opposite start buttons; you can
release the keys from the beginning of the
feeding. The procedure will continue until the
facing position is reached.
16 Opens/Closes the clamps (the LED is on when
clamps are open).
17 Selects the reset function after a new tooling:
- Press both opposite start buttons and then
the key; press and hold the keys until the
procedure is completed.
18 Bar feeder start button (green light) and "Errors"
reset: press the button to start the bar feeder
and hold it down until the button lights up.
19 Bar feeder stop button (red); press this button
to stop the bar feeder.
20 Remnant detection disabling button (white light)
Press the button to feed a "new" bar without the
detection of bar remnant in the bar pusher
collet.
21 Half-bush opening and closing button (white light)
- In "Manual" mode, when the bar feeder is in the required position, the half-bushes will
close when this button is pressed. If pressed again, the half-bushes will open.
- In "Automatic" mode, if pressed, the half-bushes will open and close, according to the
preset sequence. If pressed again, the half-bushes will remain open during the entire
operating cycle.