IEMCA BOSS 338 HD, Руководство по эксплуатации и техническому обслуживанию

Страница: 109 / 214

5 - ADJUSTMENTS AND SETUP Boss 338HD - 552HD
EN
5 - Pag. 17 / 17
5.3.2 BAR PUSHER REPLACEMENT PROCEDURE
WARNING - CAUTION
Never perform the following procedure when a bar is detected in the bar pusher
collet!
The replacement of the bar pusher, for a working cycle change or maintenance, may be
performed as follows:
- set the bar feeder to manual mode , with close guide channels;
- press and hold and , to start the automatic procedure, which allows the
bar feeder to move to the appropriate condition for the bar pusher replacement.
- In particular, by pressing , the bar pusher is positioned past the clamp device, the
guide channels open, the bar pusher moves to the completely backwards position allowing
the bar pusher removal.
INFORMATION
If during the above mentioned operations and , are released, the
procedure will stop. By pressing the button again, the procedure will start from
where it was paused.
NEW BAR PUSHER INTRODUCTION
WARNING - CAUTION:
Introduce the bar pusher correctly into the first feeding carriage housing.
- Close the bar feeder guard, reset the start button , enter the manual mode and
press with . The bar pusher moves forwards until the clamp position is
exceeded of at least 200 mm. The upper guide channels are closed.