IEMCA BOSS 338 HD, Руководство по эксплуатации и техническому обслуживанию

Страница: 56 / 214

EN
3 - SAFETY - GENERAL INFORMATION Boss 338HD - 552HD
3 - Pag. 10 / 10
BAR FEEDER FASTENING IN AN UNSTEADY EQUILIBRIUM
1) If during installation the floor proves not to be level, the authorized technician will level
out and align the bar feeder using the levelling screws of the fastening plates in the outer
part of the bar feeder and in the anti-vibration plugs in the inner part.
2) If applicable, from the bar feeder/lathe mechanical interface layout, anchor the bar
feeder to the lathe by means of a mechanical anchorage after aligning the bar feeder to
the lathe and securing it to the ground.
3) If a customer chooses not to secure the bar feeder to the ground, he will be responsible
for the bar feeder becoming unstable of falling to the ground.
Here are some examples of the warnings referenced above:
1)Once installation is complete, all supporting screws used to align the lathe spindle line with
the bar feeder line should be inserted in the plates supplied with the installation material.
2)Equipped on all cam lathes and on some CNC sliding-headstock lathes.
3)The technician will perform installation without securing the bar feeder to the ground.
However, in the report to the customer certifying that installation has been completed, he will
state that the customer requested that the machine be not secured to the ground.
BREAKING RISK DURING OPERATION
1) After performing scheduled or unscheduled maintenance work, remove any foreign
objects from inside the bar feeder inner area.
2) Stop lathe spindle rotation during the magazine loading phase.
Here are some examples of the warnings referenced above:
2)Avoid loading the magazine when there are parts rotating inside the guide channels. If they
break, they can seriously harm the operator.
RISKS FROM MOVING PARTS
1) When the guard opens during the work phase for loading the bars into the magazine,
avoid any contact with moving parts.
2) The bar pre-loading area has no guards at all and gives the operator direct access to the
work area.
Here are some examples of the warnings referenced above:
1)Bar or revolving tip rotation, bar pusher feeding, moving the synchronization device (if
present).
2)This area has no protection guard. Please note that areas with moving parts (bar pusher) can
be reached during the bar change phase.