IDS X16, Руководство по обучению

Страница: 14 / 87

14 Locations | IDS X Series Training V2.3
Locations
Location 0: Defaults
Location Type: Standard
This location is
used for defaulting the alarm system.
Value Action
0
Default the complete system back to factory settings
1
Will default the Primary Master User Code back to 1234 - or 123456 if 6 digits are being used.
Master User Code properties will also be defaulted.
2
Defaults ALL user codes and their properties.
3 Defaults ALL keypads.
4
Remove Missing Devices.
Any missing devices (keypads, for example), will have its address freed up, making its address
available for a new device when it is enrolled. This MUST be performed when replacing a faulty device.
(You must wait for 10 seconds.)
5
“Central Monitoring Mode” default setting change. Defaults some settings to factory default and
changes some others.(Implemented in vers.2 please see
appendix for complete listing)
6
“Private Reporting Mode” settings change. Defaults some settings to factory default and changes some
others (Implemented in vers.2 please see
appendix for complete listing)
7 Defaults all wireless zones and settings
Exercise: Defaulting back to factory settings
Location 1 to 8: Zone Type
Location Type: Extended Sub -Location
Can be programmed using the string method.
Loc Zone Types
[1]
Z1 Z2 Z3 Z4 Z5 Z6 Z7 Z8
01 02 04 04 04 04 04 04
2
Z9 Z10 Z11 Z12 Z13 Z14 Z15 Z16
-- -- -- -- -- -- -- --
3
Z17 Z18 Z19 Z20 Z21 Z22 Z23 Z24
-- -- -- -- -- -- -- --
4
Z25 Z26 Z27 Z28 Z29 Z30 Z31 Z32
-- -- -- -- -- -- -- --
5
Z33 Z34 Z35 Z36 Z37 Z38 Z39 Z40
-- -- -- -- -- -- -- --
6
Z41 Z42 Z43 Z44 Z45 Z46 Z47 Z48
-- -- -- -- -- -- -- --
7
Z49 Z50 Z51 Z52 Z53 Z54 Z55 Z56
-- -- -- -- -- -- -- --
8
Z57 Z58 Z59 Z60 Z61 Z62 Z63 Z64
-- -- -- -- -- -- -- --
As can be seen in the table above, Loc [1] has a square bracket around it, indicating that it is a root
location. This means that, zone types can be entered in the string method, for zones 1 to 8 or the sub-
location method for all 64 zones.
Instructions Key presses
Enter installer mode [#] [9] [9] [9] [9] [*]
Enter location zero [0] [*]
Enter a value of zero [0] [*]
The keypad will begin to beep until all locations have been reset. The LEDs on the
keypads will flash indicating that they have no IDs and the system is defaulted.
The table on the right shows each location
and the defaults programmed into them at
the time of manufacture.
Zones 1 to 8 are the only zones
programmed with zone types.
All other zones must be programmed and
allocated to a partition, as described below.
Root Location: