Ideal AKE AKV 116, Руководство по эксплуатации

Страница: 116 / 168

Subject to technical changes | Valid from July 2021
32
TECHNOLOGY
REFRIGERATED DISPLAY CASES
02
This chapter provides important information on the assembly and use of the units.
Check whether the unit has any transport damage, and note any damage discovered on the acceptance documents from the
freight forwarder as well as on your form. Have the damage confirmed.
Acceptance
2.4. ASSEMBLY AND INSTALLATION GUIDE
2.4.1. FIRST STEPS
To enable damage that is caused during loading, transport and unloading to be traced, all units are equipped with a
“ShockWatch® 2”. This tool makes it possible to determine at which point of the delivery chain a product is damaged
in order to clarify transport damage. Information on the ShockWatch® concept is stored in the QR code (see Chapter
4.2).
NOTE
If the damage is only discovered after unpacking, then you are obliged to report it immediately in writing. It is advisable to notify
your supplier by phone in advance. To remove the transport packaging you require:
• At least two persons
•
Tools:
- cordless screwdriver or Philips screwdriver
- cutting tool (scissors or knife)
Danger of the unit tipping over on an uneven and unstable subsurface
Ensure that the unit is installed exclusively on a level and adequately stable subsurface, otherwise the unit could tip over or
parts of the unit could fall off or open accidentally (drawers, hinged doors, etc.)
WARNING
All requirements at the installation site according to Chapter 1.8 must be followed in order to ensure efficient and safe operation.
Set-up
Your claim to compensation for damage will expire if you do not report transport damage in good time (in accordance
with our General Terms and Conditions of Business).
Avoid placing the unit near any equipment that produces a lot of steam. This can lead to heavy icing of the evaporator,
condensate on the glass, and other adverse effects which are unwanted and/or reduce the performance.
Correct installation and fault-free operation are requirements for putting the unit into operation. The installation must
comply with the local electrical, safety and hygiene regulations.
NOTE
NOTE
NOTE