iColor I Candy 200, Руководство пользователя

Страница: 11 / 72

|
10
User Manual – February 2020 Edition
A. Label and roll specifications continued…
M A X M I N
Label width 8.25” (209mm) 0.5” (13mm)
Liner/media width 8.375” (212mm) 1.5” (38mm)
Label height/length 24” (609mm) 0.5” (13mm)
Gap between labels 10” (253mm) 0.10” (2.5mm)
Width of through-hole opening 0.5” (12.65mm) 0.25” (6.325mm)
Gap Sensor Adjustment 1.9” (48mm) 0.20” (5.06mm)
Reflective/Black Mark Width* N/A 0.1” (2.54mm)
Max Outer Diameter (OD) 6.0” (152.4mm) N/A
Inner Core Diameter (ID) 3.0” (76.2mm) 3.0” (76.2mm)
Total Thickness (Liner + Label)** .0010” N/A
Distance from edge of media
to edge of label Printer driver assumes 2 mm gap. However, this is adjustable via the left
margin offset.
* The Reflective/Black Mark should be opaque to infrared light. The mark should be between the labels.
The end of the mark should correspond with the beginning of the label.
** This is the recommended maximum. There are two factors that determine whether the printer will accept any
particular stock thickness.
1. The ability for the printer to pull the paper through the print area.
2. The ability for the sensor to read through the backing if the sensor is set to die-cut.
If you are printing in continuous or reflective label sensing mode number 2 does not apply. The fact that the printer
must read through the backing in die-cut mode will limit the thickness much more than the printer's ability to pull
the paper through the print area. However, if you adjust opacity level of the liner enough to allow the label to be
seen by the stock sensor, the thickness will only be limited by the printer's ability to pull it through the printer
area. For these reasons the weight or thickness of the liner is a variable that cannot easily be defined. Uninet
recommends and uses 40# liner with all label stock. It is important to test all label stock with the intended printer
before ordering large quantities!