IBM TOKEN-RING PCI FAMILY ADAPTER, Руководство пользователя

Страница: 18 / 113

Installing Wake on LAN Cables for the IBM High-Speed 100/16/4
Token-Ring PCI Adapter
For instructions on using the IBM 16/4 Token-Ring PCI Adapter 2 with Wake on
LAN see “Installing Wake on LAN Cables for IBM 16/4 Token-Ring PCI Adapter 2
with Wake on LAN” on page 2-3.
1
Two Wake on LAN cables are included with your new adapter. Determine
which to connect to your adapter in the following manner.
¹
If your PC has a power supply cable marked P9 or P12, then you must
use cable part number 42H2397. This cable has two connectors; one for
the adapter and one for the system board.
¹
If the cable from the power supply is not present, then you must use part
number 76H7254. This cable has three connectors; two for the adapter
and one for the system board.
2
Connect the cables to your adapter as follows:
¹
Connect the planar connector to the system board as shown in
Figure 2-1. If you are using the two-connector cable, part number
42H2397, this connector has two pins. If you are using the
three-connector cable, part number 76H7254, this connector has three
pins.
¹
Connect the signal connector to your adapter at P5 as shown at number
2 in Figure 2-2 on page 2-3.
¹
If you are using the three-connector cable, part number 76H7254,
connect the power connector to the adapter at P4 as shown at number 3
in Figure 2-2 on page 2-3.
Otherwise, connect the power supply cable marked P9 or P12 to the
adapter at P4. See number 3 in Figure 2-2 on page 2-3.
Figure 2-1. Wake on LAN Signal Connector on the System Board
2-2
IBM Token-Ring PCI Family Adapter