IBM ThinkPad 760C, Руководство по обслуживанию

Страница: 292 / 327

Using PS2 Commands
Note:
Only on models with Mwave DSP
installed.
Sets the features for the digital signal processor (DSP).
DSP Enable | Disable
ADDress
DMA
IRQ —
0030 | 4E30 | 8E30
| CE30
0 | 1 | 6 | 7
5 | 7 | 10 | 11 | 15
Sets the features for the infrared port (IR).
IR Enable | Disable
ON | OFf
PORT
MOde
COMADDress
IRADDress
IRQ
DMA03 —
—
Front | Rear | Both
TPad | Sharp
3F8 | 2F8 | 3E8 | 2E8
1A0 | 1B0 | 1C0 | 1D0
3 | 4 | 5 | 10 | 11 | 15
Enable | Disable
Note:
Use this command before using
other hibernation commands. Creates the hibernation file.
HFILE C – Z | DELete —
Note:
Create the hibernation file using the
HFILE command before using this
command. Enters hibernation mode when the power switch is pressed.
HSWITCH Enable | Disable
Sets the timer to enter hibernation mode after the specified number of
minutes (
xx).
HTimer
xx
[AC | DC]
Note:
Create the hibernation file using the
HFILE command before using the LB
H command. Sets the power management mode to enter when a low-battery condition
occurs.
AC: Specifies battery mode when the AC Adapter is connected.
DC: Specifies ac mode when using battery power.
LBattery Suspend | Hibernation —
Note:
This command is effective on the
current power mode set by the PM
command. Sets the LCD off when there is no computer operation after the specified
number of minutes (
xx).
LCd xx —
Appendix D. Using PS2 Commands
275