IBM ThinkPad 760C, Руководство по обслуживанию

Страница: 277 / 327

Advanced Information for PC Cards
/STBTIME:
n
Specifies the time (from 1 to 21 minutes) until
entering standby mode. When the ATA card is not
accessed for the time specified by this parameter, the
ATA card enters standby mode (only when your ATA
card supports standby mode). When this parameter
is not specified, standby mode for the ATA card is
disabled.
/MDRV: n Specifies the number of extra drives that can be used
in addition to the number of PCMCIA slots available
for the PCMCIA storage devices. When this
parameter is not specified, no extra drive is given to
the device driver. The extra drives can be activated
by the PCMCIA ATA Card Mount utility. For more
information, see “ATA Card Mount Utility” on
page 65.
/!DM Specifies not to use OS2DASD.DMD as the device
manager. When this parameter is set,
OS2PCARD.DMD is used instead.
Parameters for DOS PCMCIA Storage Card Device Drivers
The following are the parameters in the DOS PCMCIA storage card
device driver and their explanations:
DEVICE=[drive:] [directory] PAWATA.SYS [/P:hhhh] [/NOBEEP]
[/STBTIME:n] [/MDRV:n]
DEVICE=[drive:] [directory] PAWATAS.SYS [/P:hhhh] [/NOBEEP]
[/STBTIME:n] [/MDRV:n]
DEVICE=[drive:] [directory] PAWATASF.SYS [/P:hhhh]
[/NOBEEP] [/STBTIME:n] [/MDRV:n] [/EMS] [/TSIZE:n]
/P: hhhh Specifies the lower limit for the I/O address of the
ATA card. The device driver assigns the next usable
I/O address from this lower limit to the card. When
this parameter is not set, the device driver looks for a
usable address and assigns that address to the card.
/NOBEEP Specifies not to beep when a storage card is
installed. When this parameter is not set, you will
hear a beep every time a storage card is installed
into the PCMCIA slot.
260
IBM ThinkPad 760C User's Guide