IBM IntelliStation A Pro 6217, Руководство по обслуживанию

Страница: 106 / 188

1. Read the safety information that begins on page vii and “Installation guidelines”
on page 79.
2. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
3. Remove the side cover (see “Removing the side cover” on page 81).
4. Remove the front bezel (see “Removing the bezel” on page 84).
5. Remove the support bracket (see “Removing the support bracket” on page 83).
6. Disconnect the cables from the drive that you are replacing.
7. Release the drive from the bay by pressing the blue latch on the side of the
drive and pull the drive out of the computer.
8. Remove the blue clip from the side of the drive and install the clip on the
replacement drive. Store the old drive in a safe place.
Replacing the drive in bay 1 or 2
To install a drive in bay 1 or 2, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 79.
2. Make sure that you have all the cables and other equipment that is specified in
the documentation that comes with the drive.
3. Check the instructions that come with the drive to determine whether you must
set any switches or jumpers on the drive. If you are installing a SCSI device,
make sure that you set the SCSI ID for that device.
4. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
5. Remove the side cover (see “Removing the side cover” on page 81).
6. Remove the front bezel (see “Removing the bezel” on page 84).
7. Remove the support bracket (see “Removing the support bracket” on page 83).
8. If the bay does not have a drive installed, use a screwdriver to pry the filler
panel and EMC shield away from the computer (see Figure 16).
EMC shield
Filler panel
Figure 16. Preparing to install a drive in bay 2
90
IBM IntelliStation A Pro Type 6217: Problem Determination and Service Guide