IBM IntelliStation A Pro 6217, Руководство по обслуживанию

Страница: 39 / 188

Table 3. POST error messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Machine Type 6217,” on page 67 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by (Trained service technician only), that step must be performed only by a
trained service technician.
Error codes Description Action
604 An error occurred during a diskette drive
test.
1. Make sure that the Configuration/Setup Utility
program correctly reflects the type of diskette drive
that you have installed.
2. Make sure that the diskette drive cables are
correctly and securely connected.
3. Reseat the following components:
a. Diskette drive
b. (Trained service technician only) System board
4. Run the diagnostic tests. If the computer fails the
diagnostic tests, replace the following components
one at a time, in the order shown, restarting the
computer each time:
a. Diskette drive
b. (Trained service technician only) System board
662 A diskette drive configuration error occurred.
1. If you removed a diskette drive, make sure that the
diskette drive setting is correct in the
Configuration/Setup Utility program. If the setting is
not correct, change it and save the setting.
2. Make sure that the diskette drive cables are
correctly and securely connected.
3. Reseat the following components:
a. Diskette drive
b. (Trained service technician only) System board
4. Run the diagnostic tests. If the computer fails the
diagnostic tests, replace the following components
one at a time, in the order shown, restarting the
computer each time:
a. Diskette drive
b. (Trained service technician only) System board
962 A parallel port configuration error occurred. If you changed a hardware option, make sure that the
parallel port setting is correct in the
Configuration/Setup Utility program. If the setting is not
correct, change it and save the setting.
1162 The serial port configuration conflicts with
another device in the system.
1. Make sure that the IRQ and I/O port assignments
needed by the serial port are available.
2. If all interrupts are being used by adapters, remove
an adapter to make an interrupt available to the
serial port, or force other adapters to share an
interrupt.
3. Make sure that the serial port setting is correct in
the Configuration/Setup Utility program. If the
setting is not correct, change it and save the
setting.
Chapter 2. Diagnostics
23