IBM IntelliStation A Pro 6217, Руководство по обслуживанию

Страница: 76 / 188

Attention: Do not press F5. Doing so changes the computer configuration.
If an ISPR error remains, complete the following steps until the error is
corrected:
a. Reseat the controller.
b. Replace the controller.
Note: If the adapter or controller detects a configuration change. Do not select
Save Changes . Instead, press F10 to bypass any options to this effect.
2. If the ISPR error is EF10 after the cables are disconnect, complete the following
steps:
a. Identify which channel is causing the error according to the second digit (z)
of the original ISPR code as indicated in the following table.
Note: ServeRAID-6i+ controllers have no channels. A ServeRAID-6i+
controller uses the channel connectors of the integrated SCSI controller.
Table 5. SCSI identifier
SCSI channel code (z) Descriptions
1 Channel 1
2 Channel 2
3 Channel 1 and 2
4 Channel 3
5 Channel 1 and 3
6 Channel 2 and 3
7 Channel 1, 2, and 3
8 Channel 4
9 Channel 1 and 4
A Channel 2 and 4
B Channel 1, 2, and 4
C Channel 3 and 4
D Channel 1, 3, and 4
E Channel 2, 3, and 4
F Channel 1, 2, 3, and 4
b. Confirm that the channels that are identified from the error in step 2a are the
cause of the error by making sure that the error occurs only when the
suspected channel is reconnected.
c. Check the termination of the identified channel.
d. Make sure that the backplane jumper configuration is correct.
e. If the computer has hard disk drive status cables, make sure that the cables
are connected correctly. Reconnect all cables that you removed in step 1 on
page 59.
f. Disconnect one drive at a time from the channel that was identified in step
2a; then, restart the computer to determine which drive is causing the error.
g. Reconnect the SCSI cable.
h. Reconnect the SCSI backplane.
60
IBM IntelliStation A Pro Type 6217: Problem Determination and Service Guide