IBM IntelliStation A Pro 6217, Руководство по обслуживанию

Страница: 75 / 188

After the update session is completed, the computer will turn off.
11. Remove the CD from the CD or DVD drive.
12. Disconnect all power cords; then, remove the computer cover and support
bracket.
13. Return the boot block recovery jumper to pins 1 and 2.
14. Replace the computer cover; then, reconnect all external cables and power
cords and turn on the peripheral devices.
15. Turn on the computer to restart the operating system.
Small computer system interface (SCSI) error codes (some models)
For any SCSI error message that you receive when running the SCSISelect Utility
program, one or more of the following devices might be causing the problem:
v
A failing SCSI device (adapter, drive, controller)
v An incorrect SCSI configuration
v
Duplicate SCSI IDs in the same SCSI chain
v
A missing or incorrectly installed SCSI terminator
v An incorrect SCSI termination jumper setting
v
A defective SCSI terminator
v An incorrectly installed cable
v
A defective cable
For any SCSI error message, follow these suggested actions in the order in which
they are listed until the problem is solved:
v Make sure that the external SCSI devices are turned on before you turn on the
computer.
v
Make sure that the cables for all external SCSI devices are connected correctly.
v
If an external SCSI device is attached, make sure that the external SCSI
termination is set to automatic.
v Make sure that the last device in each SCSI chain is terminated correctly.
v
Make sure that the SCSI devices are configured correctly.
If the problem remains, run the diagnostic programs to obtain additional information
about the failing device. If the error remains or recurs, call for service.
Note: If the computer does not have a SCSI hard disk drive, ignore any message
that indicates that the BIOS code is not installed.
Interrupt status port register (ISPR) error procedures
Use interrupt status port register (ISPR) error procedures to help you solve
ServeRAID
™
problems. A complete list of error codes is listed in “ServeRAID error
codes” on page 61.
EF10 (Default ISPR)
1. There is no ISPR error.
9zxx through Bzxx (SCSI bus error caused by cables, termination, defective
drives, or a similar problem)
1. Isolate between the SCSI subsystem and the controller by disconnecting all
SCSI cables from the suspected adapter, and restart the computer.
Chapter 2. Diagnostics
59