IBM Flex System x440 Compute Node, Инструкция по установке и обслуживанию

Страница: 509 / 584

5. Lift the CMOS battery from the socket.
What to do next
After you remove the CMOS battery, dispose of the CMOS battery as required by
local ordinances or regulations.
Installing the CMOS battery
Use this information to install a CMOS battery.
Before you begin
Before you install the CMOS battery, complete the following steps:
1. Read “Safety” on page v and “Installation guidelines” on page 487.
2. If the compute node is installed in an IBM Flex System chassis, remove it (see
“Removing a compute node from a chassis” on page 489 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
compute node with the bezel pointing toward you.
About this task
The following notes describe information that you must consider when you are
replacing the CMOS battery in the compute node:
v
You must replace the CMOS battery with a lithium CMOS battery of the same
type.
v
To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM marketing representative or authorized reseller.
v
After you replace the CMOS battery, you must reconfigure the compute node
and reset the system date and time.
v
To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v
Throw or immerse into water
v
Heat to more than 100° C (212° F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Chapter 7. Installing, removing, and replacing compute node components
497