IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 456 / 573

Replacing the Battery
Before performing the following procedure, read “Safety Notices” on page xi.
CAUTION:
A lithium battery can cause fire, explosion, or severe burn. Do not recharge,
disassemble, heat above 100°C (212°F), solder directly to the cell, incinerate, or
expose cell contents to water. Keep away from children. Replace only with the
part number specified for your system. Use of another battery may present a risk
of fire or explosion.
The battery connector is polarized; do not attempt to reverse polarity.
Dispose of the battery according to local regulations.
To replace the system’s battery, do the following:
1. On a Model 6C4, open the front and rear rack doors and put the system into the
service position as described in “Placing the Model 6C4 into the Service Position”
on page 355.
On a Model 6E4, open the bezel door.
2. Shut down the system as described in “Stopping the System” on page 350.
3. Remove the service access cover as described in “Service Access Cover Removal
(Model 6C4)” on page 357 or “Service Access Cover Removal (Model 6E4)” on
page 363.
4. Remove the front bezel as described in “Front Bezel Removal (Model 6C4)” on
page 369 or “Front Bezel Removal (Model 6E4)” on page 370.
5. Disconnect and label all power and signal cables from the media drives, located in
media bay 1 and media bay 2. Then remove the media drives as described in
“Media Removal” on page 399. Note the location of each media drive removed.
6. Remove the media device support shelf by loosening the thumbscrew and
grasping the back edge of the shelf, sliding it back, then lifting it up and out of the
system chassis.
Note: The support leg located on the bottom of the support shelf is used to
deactivate a microswitch. The microswitch is located on the CEC backplane
and when deactivated, cuts off power to many of the components and
connectors located on the CEC backplane. This support shelf must be
correctly seated and secured in position after any new FRU is added to the
system and you perform a system boot.
436 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide