IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 422 / 573

Media Replacement
To replace a media drive, do the following:
1. Before handling any card, board, or memory DIMM, be sure to use your
electrostatic discharge strap to minimize static-electric discharge. Refer to
“Handling Static-Sensitive Devices” on page 348.
2. Set any jumpers or switches on the device according to the documentation
provided with the drive.
3. Using 4 retaining screws, secure the media carrier tray to the bottom of the media
drive.
4. Insert the media drive into the media bay, pushing the drive in until the release tab
clicks into the locked position.
5. Connect the media signal and power cables to the drive.
6. Replace the bezel as described in “Front Bezel Replacement (Model 6C4)” on
page 369 or “Front Bezel Replacement (Model 6E4)” on page 370.
7. Replace the service access cover as described in “Service Access Cover
Replacement (Model 6C4)” on page 357 or “Service Access Cover Replacement
(Model 6E4)” on page 364.
8. If you are servicing a Model 6C4, push the system drawer back into the operating
position as described in “Returning the Model 6C4 to the Operating Position” on
page 356.
9. Reconnect the power source to the system.
10. Power on the system as described in “Starting the System” on page 350.
11. After the Model 6C4 has successfully powered on, close the rack doors.
After the Model 6E4 has successfully powered on, close the bezel door.
402 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide