IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 86 / 573

The System Management Services menu is
displayed. If you are loading diagnostics from the
CD-ROM, you may not have pressed the
correct key when you were trying to indicate a
service mode IPL of the diagnostic programs. If
this is the case, start again at the beginning of
this step.
If you are sure you pressed the correct key, the
device or media you are attempting to boot
from may be faulty.
1. If you are using the hardware management
console (HMC) or an ASCII terminal:
v
Select View Error Log
v
If an error is logged, check the time
stamp.
v
If the error was logged during the current
boot attempt, record it.
v
Look up the error in Chapter 5, “Error
Code to FRU Index” on page 153 and do
the listed action.
v
If no recent error is logged in the error
log, go to step 3.
2. If you are using a keyboard and a graphic
display attached to the system:
v
Select View Error Log
v
If an error is logged, check the time
stamp.
v
If the error was logged during the current
boot attempt, record it.
v
Look up the error in Chapter 5, “Error
Code to FRU Index” on page 153
v
If no recent error is logged in the error
log, go to step 3.
3. Try to boot from an alternate boot device
connected to the same controller as the
original boot device. If the boot succeeds,
replace the original boot device (for
removable media devices, try the media
first).
4. Go to “MAP 1540: Minimum Configuration”
on page 101.
You suspect a cable problem. Go to
RS/6000
Eserver
pSeries Adapters,
Devices, and Cable Information for Multiple Bus
Systems
.
All other problems. Go to “MAP 1020: Problem Determination” on
page 67.
66 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide