IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 121 / 573

MAP 1540: Minimum Configuration
Notes:
1. Be sure to unplug the power cords before removing or installing processor cards,
the PCI riser card, or the CEC backplane to avoid damage to it.
2. This MAP assumes that a CD-ROM drive is installed and connected to the
integrated EIDE adapter, and a diagnostic CD-ROM disc is available.
3. If a power-on password or privileged-access password is installed, you are
prompted to enter the password before the diagnostic CD-ROM can load.
4. The term POST indicators refers to the device mnemonics that appear during the
power-on self-test (POST).
5. The support leg located on the bottom of the media support shelf is used to
deactivate a microswitch. The microswitch is located on the CEC backplane and
when deactivated cuts off power to some of the components and connectors located
on the CEC backplane. This support shelf must be correctly seated and secured in
position after any new FRU is added to the system and you perform a system boot.
6. The service processor might have recorded one or more symptoms in its error log.
v
If you arrived here after performing a slow boot, look for a possible new error that
occurred during the slow boot. If there is a new error, and its actions call for a
FRU replacement, perform those actions. If this does not resolve the problem, go
to “Step 1540-1” on page 102.
v
If an additional slow boot has not been performed, or if the slow boot did not
yield a new error code, look at the error that occurred just before the original
error. Perform the actions associated with that error. If the problem is not
resolved, go to“Step 1540-1” on page 102.
v
If a slow boot results in the same error code, and there are no error codes before
the original error code, go to “Step 1540-1” on page 102.
It is a good idea to examine that error log before proceeding (see “System
Information Menu” on page 301).
7. The service processor might have been set by the user to monitor system
operations and to attempt recoveries. You might want to disable these actions while
you diagnose and service the system. If you disable them, make notes of their
current settings so that you can restore them before you leave. The following
settings may be of interest to you.
Chapter 3. Maintenance Analysis Procedures (MAPs)
101