IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 449 / 573

8. Replace the media device support shelf. Tighten the thumbscrew located on the
support shelf.
Note: When replacing the support shelf, ensure that the lower support leg, located
on the bottom side of the support shelf, activates the microswitch located on
the CEC backplane. Failure to do so results in the system not being able to
power-on.
9. Replace all removed media drives, ensuring that the media drives removed are
returned to the same media bay locations from which they were removed. Refer to
“Media Replacement” on page 402.
10. Reconnect all power and signal cables to their respective media drives.
11. Replace the front bezel as described in “Front Bezel Replacement (Model 6C4)” on
page 369 or “Front Bezel Replacement (Model 6E4)” on page 370.
12. Replace the service access cover as described in “Service Access Cover
Replacement (Model 6C4)” on page 357 or “Service Access Cover Replacement
(Model 6E4)” on page 364.
13. On a Model 6C4, push the system drawer back into the operating position as
described in “Returning the Model 6C4 to the Operating Position” on page 356.
14. Power on the system as described in “Starting the System” on page 350.
15. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
Chapter 9. Removal and Replacement Procedures
429