IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 149 / 573

Table 1. Service Processor Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
9116 Load system data areas
(NACA/PACA) See note 1 on page 132.
9117 Start system IPL program See note 1 on page 132.
9119 Waiting for VPD collection to
complete See note 1 on page 132.
9184 Firmware image being loaded into
service processor’s control storage
during firmware update. 1. Remove, then reapply power to
the system. If the service
processor enters recovery
mode, (indicated by A1FD 0000
in the display), attempt to
update the firmware again in
recovery mode. If the service
processor comes up to the OK
prompt, try again to update the
firmware using the service
processor menus.
2. Call service support.
91C4 Flash update pending, either a
firmware update or hypervisor
dump. Note: This checkpoint may be
displayed during the firmware
update process. The checkpoint
may be displayed for a long period
of time during the process. If
process does not complete, the
system may be hung.
See note 1 on page 132.
91FF Control being handed to system
processor from service processor See note 1 on page 132.
9200 Scan interface BATs See note 1 on page 132.
9300 Logic BIST See note 1 on page 132.
9301 Scanned ABIST See note 1 on page 132.
9302 Dedicated ABIST See note 1 on page 132.
9303 Dedicated ABIST array fuse repair
calculation See note 1 on page 132.
9380 Built-in-self-test (BIST) See note 2 on page 133.
9400 Service processor is requesting
system flush See note 1 on page 132.
9410 Service processor is issuing request
to start instruction execution See note 1 on page 132.
9411 Service processor is issuing request
to stop instruction execution See note 1 on page 132.
9420 Service processor is issuing request
to start system clocks See note 1 on page 132.
Chapter 4. Checkpoints
129