IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 152 / 573

Table 1. Service Processor Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
A809 Flash erase start See note 1.
A80A Flash erase end See note 1.
A80B Reserved; not used See note 1.
A80C Reserved; not used See note 1.
A80D Reserved; not used See note 1.
A80E Reserved; not used See note 1.
A80F Service processor dump done See note 1.
A810-A8FF Scan log dump in progress Informational message. (See “Scan
Log Dump Policy” on page 293.)
The last two characters of the
checkpoints will change as the scan
log dump progresses. If the last two
characters do not change after 5
minutes, the service processor is
hung and must be reset. Follow the
procedure outlined in Note 1
following this table.
When the scan log dump is
complete, depending on how the
reboot policy is set, the system will
either:
v
Go to the standby state (and the
service processor menus will be
available), indicated by OK or
STBY in the operator panel,
OR
v
Attempt to reboot.
B0F5 Delayed power-off sequence has
begun See note 1.
B0FA Delayed power-off acknowledged See note 1.
B0FF Power-off requested program
executing See note 1.
Notes:
1. If the system fails to progress after this checkpoint is put in the display, do the
following:
a. Activate the service processor pinhole reset switch on the system’s operator
panel.
b. If the hang repeats, check with service support to see if there is a firmware
update that fixes the problem.
c. If not, or the update does not fix the problem, replace the CEC backplane,
location: U0.1-P1.
d. If this procedure does not fix the problem, call service support.
132 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide