IBM 7013 J Series, Руководство оператора

Страница: 63 / 297

Using the System Unit
2-31
Unloading the 4 mm Tape Cartridge
Before performing the unload operation, make sure the power to the 4 mm tape drive is on.
To unload and eject the tape cartridge, press the unload button. The 4 mm tape drive
rewinds the tape and then ejects the tape cartridge from the tape drive.
After pressing the unload button, the following will occur:
1. The Read-Write status light will flash during the unload operation.
2. The Ready status light and the Read-Write status light will turn off when the
cartridge is ejected from the tape drive.
Read-Write Status Light
(Green)
Write-Protect Tab
4 mm Tape Cartridge
Ready Status Light
(Green)
Unload Button
The time required for a tape to rewind and unload is between 10 seconds and 1.5 minutes,
depending on the position of the tape when the unload button is pushed.
If the tape cartridge cannot unload and has to be removed manually from the drive, see
“Manually Removing the Tape Cartridge” in
Diagnostic Information For Micro Channel Bus
Systems.