IBM 7013 J Series, Руководство оператора

Страница: 156 / 297

5-4
Operator Guide
General Attributes Always Required
The general attributes in the following table are the default settings for the diagnostic
programs. Be sure your terminal is set to these attributes.
Note: These attributes should be set before the diagnostic programs are loaded.
General
Setup
Attributes 3151
/11/31/41
Settings 3151
/51/61
Settings
3161/3164
Settings
Description
Machine
mode IBM 3151 IBM
3151 PC IBM 3161
or
IBM 3164 The diagnostic programs are set to
emulate use of the 3161 ASCII
Display Terminal. If your terminal can
emulate a 5085, 3161 or 3164
terminal, use the following attribute
settings. Otherwise, refer to your
operator’s manual, compare the
following attribute descriptions with
those of your terminal, and set your
attributes accordingly.
Generated
Code Set ASCII
Screen Normal Normal Uses the EIA-232 interface protocol.
Row and
Column 24 x 80 24 x 80 Uses the EIA-232 interface protocol.
Scroll Jump Jump Jump When the last character on the bottom
line is entered, the screen moves
down one line.
Auto LF Off Off Off For the “On” setting, pressing the
Return key moves the cursor to the
first character position of the next line.
For the “Off” setting, pressing the
Return key moves the cursor to the
first character position of the current
line. The CR and LF characters are
generated by the New line setting.
CRT saver Off Off 10 The “10” setting causes the display
screen to go blank if there is no
activity for 10 minutes. When the
system unit sends data or a key is
pressed, the display screen contents
are displayed again.
Line wrap On On On The cursor moves to the first
character position of the next line in
the page after it reaches the last
character position of the current line in
the page.
Forcing
insert Off Off