IBM 7013 J Series, Руководство оператора

Страница: 155 / 297

Using the Diagnostics
5-3
Running the Diagnostic Programs from the Network
Consider the following when you run the diagnostic programs from a network:
•
Diagnostics cannot be loaded and run from the network until AIX Version 3.2 or higher
has been installed and configured on the server.
•
Your system unit must be configured to receive IPL (initial program load) over the network
or the server must be setup to send a service mode IPL of the diagnostics.
To run the diagnostic programs from the network:
•
Enter the shutdown –F command to shut down the operating system.
•
Turn the key mode switch to the Service position.
•
Turn off the system unit, wait 30 seconds, then turn on the system unit.
Running the Diagnostic Programs from a TTY Terminal
Consider the following when you run diagnostic programs using a tty-type terminal as the
console display:
•
See the operator manual for your type of tty terminal to find the key sequences you need
to respond to the diagnostic programs. For the 3151, refer to the
3151 ASCII Display
Station Guide to Operations, form number GA18-2633. For the 3164, refer to the 3164
ASCII Color Display Station Description, form number GA18-2617.
•
When the diagnostic programs present display information through the S1 port, certain
attributes are used. These attributes are set as if the diagnostic programs were using a
3161 display terminal. The following tables list attributes for the 3161 ASCII Display
Terminal and for two other ASCII display terminals commonly used with the system.
•
If you have a tty terminal other than a 3151, 3161 or 3164 attached to the S1 port, your
terminal may have different names for the attributes. Use the attribute descriptions in the
following tables to determine the settings for your terminal.