Hyster S40XM, Руководство по эксплуатации

Страница: 65 / 134

MAINTENANCE
63
tow the disabled lift truck. This
1
/
2
capacity load will in-
crease the traction of the lift truck. Keep the load as low
as possible.
5. Use a towing link made of steel that fastens to the tow
pins in the counterweights of both lift trucks.
HOW TO PUT A LIFT TRUCK ON BLOCKS
WARNING
The lift truck must be put on blocks for some types of
maintenance and repair. The removal of the following
assemblies will cause large changes in the center of
gravity: mast, drive axle, engine and transmission,
and the counterweight. When the lift truck is put on
blocks, put additional blocks in the following posi-
tions to maintain stability:
1. Before removing the mast and drive axle, put
blocks under the counterweight so that the lift
truck can not fall backward.
2. Before removing the counterweight, put blocks
under the mast assembly so that the lift truck
can not fall forward.
The surface must be solid, even, and level when the
lift truck is put on blocks. Make sure that any blocks
used to support the lift truck are solid, one piece
units.
NOTE: Some lift trucks have lifting eyes. These lifting
eyes can be used to raise the lift truck so that blocks can
be installed.
How To Raise the Drive Tires (See FIGURE 7.)
1. Put blocks on each side (front and back) of the steering
tires to prevent movement of the lift truck.
2. Put the mast in a vertical position. Put a block under
each outer mast channel.
3. Tilt the mast fully forward until the drive tires are raised
from the surface.
4. Put additional blocks under the frame behind the drive
tires.
5. If the hydraulic system will not operate, use a hydraulic
jack under the side of the frame near the front. Make sure
that the jack has a capacity equal to at least half the
weight of the lift truck. See the Nameplate.
Property of American Airlines