HydroQuip 8800 BP Series, Руководство по установке и эксплуатации

Страница: 36 / 52

referred to as the heater pump or main pump as the “heater pump.”
The heater pump can be either a 1 or 2 speed pump.
READY Mode - If the heater pump is a 2-Speed Pump 1, will circulate water every 1/2 hour, using Pump 1 Low, in order to
maintain a constant water temperature, heat as needed, and refresh the temperature display. This is known as “polling.”
REST Mode - Will only allow heating during programmed lter cycles. Since polling does not occur, the temperature display
may not show a current temperature until the heater pump has been running for a minute or two.
Ready-in-Rest Mode
READY/REST appears in the display if the spa is in Rest Mode and Jet 1 is pressed. It is assumed that the spa is being used
and will heat to set temperature. While Pump 1 High can be turned on and off, Pump 1 Low will run until set temperature
is reached, or 1 hour has passed. After 1 hour, the System will revert to Rest Mode. This mode can also be reset by entering
the Mode Menu and changing the Mode.
READY SET SET REST
The Main Screen will display RUN PUMP FOR TEMP if the ltration pump has not run for over 1 hour.
The Main Screen will display normally during Filter Cycles or when the spa is in use.
If the ltration pump has been off for an hour or more, when any function button, EXCEPT Light, is pressed on the panel,
the pump used in conjuncton with the heater will run so that temperature can be sensed and displayed.
1 Hour
REST RANGE REST RANGE REST RANGE REST RANGE REST RANGE
While the Temperature is
still ashing, press Light
repeatedly until MODE
appears in the LCD.
SET RANGE
Main Screen
READY RANGE FLTR1
Main Screen
REST RANGE FLTR1
Main Screen
REST RANGE FLTR1
Toggle between READY and REST
Pressing Light when the display is toggled will go to Main Screen.
To next item in
Main Menu
If not toggled
Waiting
Several Seconds
Reverts to Original Setting
To Set
*****
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that performs this function is
MODE SETTINGS
Setting Modes
Key
A temperature button, used for “Action”
Light or dedicated “Choose” button, depending on control panel conguration
Waiting time that keeps the last change to a menu item.
Waiting time (depends on menu item) that reverts to original setting and
*****
ignores any change to that menu item.
31