background image

1

Model: MCVT120-150

PLUG IN CoNveCtIoN heater 

wIth bUILt-IN ProGraMMabLe 

therMostat

IMPORTANT  

PleAse NOTe WheN yOu OPeN The CARTON CARefully CheCk The uNIT 

ANd MAke suRe TheRe Is NO dAMAge. If yOu hAVe ANy PRObleMs WITh 

The uNIT, WITh hOW The VARIOus fuNCTIONs WORk, dAMAged OR MIssINg 

PARTs PleAse CAll 1-800-459-4409 (9 AM TO 5 PM esT) IMMedIATely fOR 

seRVICe. 
NOTe: dO NOT ReTuRN uNIT TO The sTORe befORe CAllINg The TOll fRee 

NuMbeR. dO NOT dIsPOse Of yOuR CARTONs uNTIl yOu ARe COMPleTely 

sATIsfIed WITh yOuR NeW CONVeCTOR heATeR.

INstrUCtIoN MaNUaL

ATTeNTION: 

1.  Find a location for the convection heater that is protected from direct sunlight.

2. Do not plug the unit into the power outlet before reading all instructions.

IMPortaNt saFetY INstrUCtIoNs

WheN usINg eleCTRICAl APPlIANCes, bAsIC PReCAuTIONs shOuld AlWAys 

be fOllOWed TO ReduCe The RIsk Of fIRe, eleCTRIC shOCk, ANd INJuRy 

TO PeRsONs, INCludINg The fOllOWINg:

1)  Read all instructions carefully before using the heater.
2)  This heater is hot when in use. To avoid burns, do not let bare skin touch 

hot surfaces. If provided, use handles when moving this heater. keep 
combustible materials such as furniture, pillows, bedding, papers, clothing 
and curtains at least 3 feet (0.9 m) away from front, sides and rear of the 
heater.

3)  extreme caution is necessary when any heater is used by or near children 

or individuals with disabilities and whenever the heater is left operating and 
unattended.

4)  do not operate the heater with a damaged cord or plug or if the heater 

malfunctions, has been dropped or damaged in any manner. disconnect 
power at service panel and have heater inspected by a qualified electrician 
before use.

5)  do not use outdoors.
6)  This heater is not intended for use in bathrooms, laundry areas or in wet 

or moist indoor locations. Never place the heater where it may fall into a 
bathtub or other water containers.

7)  To disconnect the heater, turn controls to Off then remove plug from outlet.
8)  do not insert or allow foreign objects to enter any ventilation or exhaust 

openings as this may cause an electric shock, fire or may damage the heater. 
do not use on soft surfaces, such as a bed where openings may become 
blocked.

9)  To prevent possible fire, do not block air intakes or exhaust in any manner.
10)  heaters may have hot and sparking parts inside. do not use it in areas where 

gasoline, paint or flammable liquids are used or stored.

11)  use this heater only as described in this manual. Any other use not 

recommended by the manufacturer may cause fire, electric shock or injury to 
persons.

12)  do not run the electric cord under carpeting. do not cover the cord with 

throw rugs, runners or similar coverings. do not place the cord in a traffic 
area.

13)  Always plug heater directly into a wall electrical outlet. Never use with an 

extension cord or power bar.

14)  Always unplug heater when not in use.
15)  Connect to properly grounded outlets only.
16)  Avoid the use of extension cord as the cord may overheat and cause a risk of 

fire. however, if you must use an extension cord, the plug must be a grounding 
type, 3-wire cord, No. 14 AWg minimum size and rated not less than 1875 
watts.

save these INstrUCtIoNs For FUtUre Use.

WARNINg:
PROCeduRes ANd TeChNIques If NOT CARefully fOllOWed WIll ResulT 

IN dAMAge TO The equIPMeNT ANd WIll exPOse The useR TO The RIsk Of 

seRIOus INJuRy, IllNess OR deATh. 
ThIs heATeR Is fOR use ON 120 VOlTs. The CORd hAs A Plug As shOWN 

AT A IN IllusTRATION belOW. AN AdAPTeR As shOWN AT C Is AVAIlAble 

fOR CONNeCTINg ThRee-blAde gROuNdINg-TyPe Plugs TO TWO-slOT 

ReCePTACles. The gReeN gROuNdINg Plug exTeNdINg fROM The AdAPTeR 

MusT be CONNeCTed TO A PeRMANeNT gROuNd suCh As A PROPeRly 

gROuNded OuTleT bOx. The AdAPTeR shOuld NOT be used If A ThRee-slOT 

gROuNded ReCePTACle Is AVAIlAble. 

GeNeraL INForMatIoN

This convection heater is intended for permanent wall-mounting with the provided 
brackets.

The heater has a thermal cut-off protection. If the thermal cut-off protection trips, switch 
off the power. The unit should reset automatically after 10 minutes. If the thermal cut-off 
protection trips again, determine the reason for overheating.

sPeCIFICatIoNs

MOdel

VOlTs

WATTs heIghT WIdTh dePTh

MCVT120-150

120VAC

1500W

443MM

581MM

112MM  

Содержание MCVT120-150











Отзывы: