HydroQuip 8800 BP Series, Руководство по установке и эксплуатации

Страница: 27 / 52

22
Step 4
- Connect spaside to an empty
connection marked MAIN. (Fig.4)
*Must align Locking Clip on spaside plug
with Locking Tab on circuit board for proper
function.
MAIN MAIN
J22
TEMP SENSORS
J16 J17
J28 AUX FRZ
J23
SERIAL
J108
EXPANDER
HTR
DISBL J29
VAC
Locking Clip* Locking Tab*
Spaside
Plug
Fig.4
Circuit
Board
When utilizing a
spaside extension
cord, the clip and
tab must also be
aligned at all
connections.
Fig.5
Fig.5
Cord plugs are labeled to insure proper
plug alignment as shown in
Fig.6
Fig.6
Front side Back side
CONNECTING SPASIDE & EXTENSION
SPASIDE CONTROL INSTALLATION
Step 1
- Clean area and insert spaside
control. (Fig.1)
Overlay & Spaside may vary
Step 2 -
Remove the double sided adhesive
from the back of the spaside. Make certain
the spaside is straight and adhere to the spa
shell. (Fig.2)
If required, you may have to cut out a hole in the spa shell to install spaside control.
Ÿ
The mounting area must be above the maximum water level of the spa and in an area with
good drainage to prevent any standing water on or around the spaside.
Ÿ
The spaside should never be submerged.
Ÿ
The spaside should be protected from extended periods of exposure to sunlight.
Ÿ
Do not step or stand on the spaside
Step 3
- Remove protective film from display
window then clean the face of the spaside.
Now carefully align and apply the label. (Fig.3)
Fig.3
Fig.1
Fig.2
CAUTION:
Damage may occur to the circuit board and spaside if the spaside
plug is not properly aligned to the receptacle on the circuit board or if the
spaside plug is connected or disconnected while the power is on.
**Any resulting damages are not covered under manufacturer’s warranty**
ATTENTION! The plug connectors must be placed in a protected area so moisture,
dirt or chemicals are not allowed to infect this link.