HydroQuip 8800 BP Series, Руководство по установке и эксплуатации, Страница: 34 / 52

Pumps
Press the “Jets 1” button once to turn pump 1 on or off, and to shift between low- and high-speeds if equipped.
If left running, the pump will turn off after a time-out period. The pump 1 low-speed will time out after 30 minutes. The
high-speed will time out after 15 minutes.
the low-speed of pump 1 runs when the blower or any other pump is on. If the spa is in Ready Mode
(See page 7), Pump 1 low may also activate for at least 1 minute every 30 minutes to detect the spa temperature (polling)
and then to heat to the set temperature if needed. When the low-speed turns on automatically, it cannot be deactivated
from the panel, however the high speed may be started.
The system is factory-programmed with one lter cycle that will run in the evening (assuming the time-of-day is properly
set) when energy rates are often lower. The lter time and duration are programmable.
A second lter cycle can be enabled as needed.
At the start of each lter cycle, the blower (if there is one) or Pump 2 (if there is one) will run briey to purge its plumb-
ing to maintain good water quality.
P
P
SET P SET P SET P SET P
To next item in
Main Menu
While the Temperature is
still ashing, press Light
repeatedly until TIME
appears in the LCD.
If Time of Day is not actually programmed due to a power cycle,
SET TIME will appear in the menu instead of just TIME.
SET RANGE
Main Screen
READY RANGE FLTR1
Main Screen
READY RANGE FLTR1
Several Seconds
Main Screen
READY RANGE FLTR1
Waiting
Several Seconds
Reverts to Original Setting
To Set
*****
Setting the time-of-day can be important for determining ltration times and other background features.
When in the TIME menu, SET TIME will ash on the display if no time-of-day is set in the memory.
will be stored. If lter cycles are required to run at a particular time of day, resetting the clock will return the lter times
to the actual programmed periods.
When the system starts up, it defaults to 12:00 Noon, so another way to get lter times back to normal is to start up the
spa at noon on any given day. SET TIME will still ash in the TIME Menu until the time is actually set, but since the spa
started at noon, the lter cycles will run as programmed.
Note:
Key
A temperature button, used for “Action”
Light or dedicated “Choose” button, depending on control panel conguration
Waiting time that keeps the last change to a menu item.
Waiting time (depends on menu item) that reverts to original setting and
*****
ignores any change to that menu item.
automatically activate to provide freeze protection. The pump(s) and blower will run either continuously or periodically
depending on conditions.
SYSTEM FUNCTIONS / FEATURES
Filtration and Ozone
Pump 1 low and the ozone generator will run during ltration.
Freeze Protection
If the temperature sensors within the heater detect a low enough temperature (44°F) , then the pump(s) and the blower
SETTING THE TIME-OF-DAY
If power is interrupted to the system, Time-of-Day is not stored. The system will still operate and all other user settings
29