Husqvarna Viking Designer Jade 35, Руководство пользователя

Страница: 61 / 84

Attaching the Embroidery/Darning
Foot U
1. Turn off the power switch to prevent accidents.
2. Turn the hand wheel toward you until the needle is at its
highest point.
3. Raise the presser foot.
4. Remove the presser foot and holder by removing the
presser foot screw (A).
5. Change the needle to an embroidery needle (B).
6. Attach the Embroidery/Darning Foot U to the presser
bar (C) so that the arm (D) of foot rides on the shaft (E)
of the needle clamp.
7. Attach the presser foot screw (A) and tighten it. For
easier access, lower the needle slightly.
To Hoop the Fabric
For the best embroidery results, place a layer of stabilizer
beneath the fabric. When hooping stabilizer and fabric make
sure that they are smooth and securely hooped.
1. Open the quick release (A) on the outer hoop and loosen
the screw (B). Remove the inner hoop. Place the outer
hoop on a firm flat surface with the screw on the lower
right (B). There is a small arrow in the center of the lower
edge of the hoop which will line up with a small arrow on
the inner hoop.
2. Place the stabilizer and fabric, with the right sides facing
up, on top of the outer hoop. Place the inner hoop on
top of the fabric with the small arrow at the bottom edge.
If you can see the hoop size in the lower part of the inner
hoop, you have attached it correctly.
3. Push the inner hoop firmly into the outer hoop.
4. Close the quick release (A). Adjust the pressure of the
outer hoop by turning the retaining screw (B). The fabric
should be taut in the hoop for the best results.
Note: When embroidering additional designs on the same fabric, open
the quick release, move the hoop to the new position on the fabric and
close the quick release. When changing type of fabric, you might need to
adjust the pressure using the retaining screw. Do not force the quick
release.
6 Embroidery Preparations 61