HP Vectra VE4, Руководство пользователя

Страница: 67 / 141

HP Vectra PC User's Guide 3 Installing Accessories In Your PC
••
67
Using the Setup Program to Configure the PC
Start the Setup program by pressing [F2] after the power-on system hardware test program
has completed, then refer to the relevant section below that describes the accessory or
accessories that you have installed.
Main Memory
Main memory is automatically configured.
1. If main memory now exceeds 16 MB and you are running applications designed for 286
and earlier processors that cannot work with more than 16 MB total memory, set the
16
MB Memory Limit
to
Yes
.
2. If you are running applications that specifically require a memory base of 512 KB, set
the
Memory Base, on System
to
512 KB
.
3. If you have no other changes to make, press [F3] to save the settings and exit the
Setup program.
Cache Memory
1. Check that the
All Memory Cache
field is set to
On
.
2. If you have no other changes to make, press [F3] to save the setting and exit the Setup
program.
Video Memory
If you are using Windows, it is recommended that you use the Video Mode utility in HP User
Tools to select settings (see “Using the HP User Tools”).
For a list of additional settings available after installing extra video memory, see “Available
Video Resolutions.” To enter the new settings:
1. Select the resolution that you wish to change, for example 800x600 and set the refresh
rate required from the list provided. Repeat for each resolution you wish to change.
2. If you have no other changes to make, press [F3] to save the setting and exit the Setup
program.
Accessory Boards
•
If you have installed an ISA board with memory mapped below 1 MB, highlight the
Memory Hole Below 1 MB
, then specify the board’s memory, and its location in main
memory between 0C8000h and 0DFFFFh. (Refer to the board’s manual for details.)
•
If you have installed an ISA board that uses IRQ 9, 10, 11, or 15, you must tell the
Setup program which IRQ it uses. This allows PCI devices to be automatically
configured. You should always leave at least one IRQ free for use by the integrated PCI
devices.
IRQ 12 is normally used by the mouse. If you do not use a mouse, IRQ 12 can be made
available.
1. Highlight the IRQ field you want to change, for example IRQ 11.