HP E8402A, Руководство пользователя и обслуживания, Страница: 72 / 249

74 Programming the Enhanced Monitor Chapter 3
HISTory:RESet[:ALL]
HISTory:RESet:BLOWer [<
blower >]
HISTory:RESet:CURRent [< supply >]
HISTory:RESet:POWer [< supply >]
HISTory:RESet:QUEue
HISTory:RESet:TEMPerature [<
slot >]
HISTory:RESet:VOLTage [< supply >]
The HISTory:RESet commands erase all data being held by the HISTory subsystem:
histograms, minimum/maximum values, and the history queue. For example,
HIST:RES:ALL erases all historical data; HIST:RES:BLOW erases the historical data
stored for the specified <blower>, HIST:RES:CURR erases the amperage historical
data for the specified <supply>, etc. The HISTory:RESet command does not erase
stripchart data. The following table describes the commands and their parameters.
These commands are not allowed while the mainframe’s power is off.
Parameters
Command Parameter(s) Range Default Description
[:ALL] Erases all historical data. The history queue retains two entries
(ALL HISTORY RESET, and QUEUE RESET) marking the time
between manufacture and the HISTory:RESet. These commands
are not allowed while the mainframe’s power is off.
:BLOW < blower> BLOWer1,
BLOWer2,
BLOWer3 none Selects the fan whose historical data is to be erased. BLOWer1 is
the main cooling fan, BLOWer2 is the Power Supply cooling fan,
BLOWer3 is a second Power Supply cooling fan on the HP
E8404A mainframes.
:CURR < supply> P5, P12, N12, P24,
N24, N5PT2, N2,
P5STby none Erases the amperage historical data for the selected < supply>.
Selects the power supply whose historical data is to be zeroed.
P5 is positive 5 Vdc supply, N12 is negative 12 Vdc supply, etc.
:POW <
supply>
P5, P12, N12, P24,
N24, N5PT2, N2, TOTal none Erases the wattage historical data for the <
supply>. Selects the
power supply whose historical data is to be zeroed. P5 is
positive 5 Vdc supply, N12 is negative 12 Vdc supply, etc.
:QUE Erases all the events stored in the history queue. One event is
put in the history queue on this command: an event logging the
time since manufacture of the mainframe until the
HIST:RES:QUE command. This is a completely destructive
command. There is no retrieving the history queue. It is primarily
needed if the history queue has filled up.
:TEMP < slot> OUT0…OUT12,
DELTa0…DELTa12,
AMBient
PSUPply none Absolute Slot Temperature Histogram
Delta Slot Temperature Histogram
Ambient Temperature Histogram
Power Supply Temperature Histogram
:VOLT < supply> P5, P12, N12, P24,
N24, N5PT2, N2 none Erases the voltage historical data for the selected < supply>.
P5 is positive 5 Vdc supply, N12 is negative 12 Vdc supply, etc.