Hoppecke trak | systemizer dynamics, Инструкция по установке, эксплуатации и обслуживанию

Страница: 50 / 63

51
- When pressing the pause key for less than 1 sec, the charging process will be
interrupted, and the charger will change into the pause mode. The green LED
"100 %" and the middle yellow LED will flash alternately.
(If charging is interrupted in this way, intermediate charging can be terminated by
disconnecting the charger from the mains voltage).
- When pressing the pause key once again for less than 1 sec, the charging
process will continue again.
Depending on the battery’s charging level, either the
green LED "100 %" or one of the yellow LEDs will light.
-
If the charger’s conditions do not change, the charging process will continue
automatically after 1 min.
Depending on the battery’s charging level, either the
green LED "100 %" or one of the yellow LEDs will light.
- When pressing the pause key for longer than 3 sec, the charger will be switched
off and re-started after15 sec.
7.2.4. Charging Process
1. The charging process automatically starts 5 seconds after the charger has been
connected to the power supply.
2. The charging process is automatically ended as soon as the battery is completely
charged. The green "100%" LED signalises the end of the charging process, as well as
the trickle charging.
3. As long as the battery is not separated from the charger, the trickle charging process
specified for the engaged battery is affected.
4. End the charging process or the trickle charging by pressing the "Pause" key on the
charger for less than 1 second. The charging process is then interrupted for 1 minute
and continued, provided that the charger state does not change.
5. Disconnect the power plug while the charger is in standby mode in order to end the
charging process.
6. Reconnect the power cable to the charger housing or to the standing device.
7. Seal the charger housing using the turning lock in order to avoid the penetration
of moisture and dust in driving mode and to restore conformance with the IP54 protection
class. Once again, use the socket wrench provided to do this.
8. When using a standing charger, remove the battery receptacle from the charging plug of
the charger and connect it to the vehicle plug, so that the vehicle is made ready for
operation. (Not required for onboard chargers)
Please refer to the separate manual provided for detailed information regarding the operation of
the charger.
ATTENTION!
trak | systemizer dynamics can be charged within a temperature range of -5°C to +40°C.