HEIDENHAIN 548431-05, Руководство пользователя, Страница: 648 / 722

Organization mode of operation | Transfer submode
9
648
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Ethernet interface (for software 548431-05)
Introduction
The control is shipped with a standard Ethernet card to connect the
control as a client in your network.
The control transmits data via the Ethernet card with:
The
SMB
protocol (Server Message Block) for Windows
operating systems, or
The
TCP/IP protocol family (Transmission Control Protocol/
Internet Protocol) and with support from the NFS (Network File
System). The control also supports the NFS V3 protocol, which
permits higher data transfer rates
Connection possibilities
You can connect the Ethernet card in your control to your network
over the
RJ45
connection, or directly to a PC. The connection is
metallically isolated from the control electronics.
The maximum cable length between control and a node
depends on the quality grade of the cable, the sheathing
and the type of network.
If you connect the control directly with a PC you must
use a crossover cable.
Have a network specialist configure the control.
Please note that the control performs an automatic
restart if you change the IP address of the control.
Configuring the control
Calling the general network settings:
Press the DEFINE NET soft key to enter the
general network settings
The
Computer name tab is active
Setting Meaning
Primary interface Name of the Ethernet inter-
face to be integrated in your
company network. Only active
if a second, optional Ethernet
interface is available on the
control hardware
Computer name Name displayed for the control
in your company network
Host file
Only required for special
applications!
Name of a file in which the
assignments of IP address-
es to computer names are
defined
Select the
Interfaces
tab to enter the interface settings