HEIDENHAIN 548431-05, Руководство пользователя, Страница: 19 / 722

Fundamentals | Software and features
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
19
New functions of software 54843x-05
The control displays error messages of different classes in
various colors, see "Display of errors", Page 71
If the programmed spindle speed is displayed in red in the
machine data display, a limitation is active and the programmed
nominal value will not be reached, see "Machine data display",
Page 102
Additional functions were added to the machine data display,
e.g. a handwheel symbol and the C axis datum shift, see
"Machine data display", Page 102
To restart the control only, the
RESTART soft key was added, see
"Switch-off", Page 95
In
Teach-in
submode, the input range for the
Angle in the B
axis BW cycle parameter in the T,S,F dialog was extended to
four decimal places.
In
Teach-in
submode and in DIN Programming, the input range
for Thread pitch was extended to 4 decimal places.
In
Simulation
submode, the
Mark the machining area
miscellaneous function was added, see "Mark the machining
area", Page 552
In
Simulation submode, the C0 – Marking on workpiece/3D
miscellaneous function was added, see "C0 – Marking on
workpiece/3D", Page 553
In
Simulation submode, a new status display was added, see
"Status display", Page 537
In 3-D simulation, tool holder display is now supported, see "3-D
simulation in Simulation submode", Page 554
In
Program run submode, it is possible to display the variables
defined in the PROGRAM HEAD program section, see "Program
execution", Page 146
In
Tool editor operating mode, you can edit the diagnostic
bits displayed in the open tool dialog, see "Diagnostic bits",
Page 570
In
Tool editor
operating mode, the
Max. shaft speed NMX
tool parameter was added, see "General tool parameters",
Page 576