HEIDENHAIN 548431-05, Руководство пользователя, Страница: 375 / 722

Teach-in | Milling cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
375
ICP contour axial
Select
Milling
Select ICP contour axial
Depending on the parameters, the cycle mills one of the following
contours or roughs/finishes a pocket on the face.
Cycle parameters:
X , Z : Start point
C : Spindle angle – C-axis position
Z1
:
Millg. top edge
(default:
Starting point Z
)
P2 : Milling depth
I : Contour-parallel oversize
K : Infeed-direction oversize
P : Feed depth (default: total depth of one infeed)
FZ
:
Approach feed
(default: active feed rate)
E : Reduced feed for circular elements (default: active feed rate)
FK : ICP contour number
T
:
Tool number
– turret pocket number
G14 : Tool change point
Further information:
"Tool change point G14", Page 180
ID : ID no.
S : Cutting speed or Constant speed
F : Feed per revolution
O
:
Roughing/Finish
– Only for pocket milling
0: Roughing
1: Finishing
H
:
Mill cutting direction
0: Up-cut
1: Climb
U : Overlap factor – defines the overlap of milling paths (default:
0.5) (range: 0 to 0.99)
Overlap =
U * milling diameter
U = 0 or no input: Contour milling
U > 0: Pocket milling – Minimum overlap of milling paths = U
* milling diameter
JK
:
Contour milling
– Input is evaluated only for contour milling
0: On the contour
1: Within the contour
2: Outside the contour
JT : Pocket milling – Input is evaluated only for pocket milling
0: From the inside out
1: From the outside in