HEIDENHAIN 548431-05, Руководство пользователя, Страница: 258 / 722

Teach-in | Recessing cycles
5
258
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
In this cycle you can specify how the floor element is
machined during the finishing process.
The control evaluates the
recessFinishing (602414)
machining parameter for this purpose. If this parameter
is not defined, the floor element is divided in the center.
Cycle run:
1 Calculate the recess positions and the proportioning of cuts
2 Approach the workpiece for the next recess on a paraxial path
from the Start point or from the last recess
3 Move to the End point contour Z2 at the programmed feed
rate
4 Remain at this position for the dwell time Delay EZ
5 Retract and approach for the next pass
6 Repeat 3 to 5 until the complete recess has been machined
7 Repeat 2 to 6 until all recesses have been machined
8 Return to the
Start point
on a paraxial path
9 Move to the Tool change point according to the setting in G14