Media-Mate Plus Operation Manual
25-710-800-O
Section One – Safety Considerations
General
1.
The Instrument should be on its own circuit to prevent problems and circuit overload.
2.
Never work on the electrical components in the system while there is power to the
Instrument. Disconnect power:
Do not run Instrument with the protective cover
removed from the electrical control cabinet.
3.
Do not fill the tank through the filter port on the tank; the Instrument may not handle the
back-pressure.
4.
Review all safety and environmental precautions pertaining to any chemicals that are to
be used in conjunction with this Instrument.
Safety Markings
For your own safety, you must observe the following safety warning signs. The safety warning
signs indicate a possible source of danger and provide preventative information.
Sign
Location
Safety Warning
Control Panel
Caution! Keep media and other liquids away from the
control panel and away from all electrical components.
Control Panel
Caution! Do not press start switch until indicator lights
are off.
Control Panel
Caution! Do not restart Instrument with liquid in flasks
without consulting troubleshooting section.
Interface Panel
Heater
Caution: No operator-accessible parts inside. Refer
servicing to qualified personnel only. Risk of electrical
shock. Do not open.
Achtung: Es gibt keine vorn Benutzer zo wanenden
Teile. Oberlassen Sie Reparaturen dem qualifizierten
Service-fachmann. Hochspannung. Nicht öffnen.
Attention: Aucune pièce remplaçable par l’utilisateur.
Toute réparation doit être effectuée par un technicien
qualifié. Risque d’ electrocution. Ne pas ouvrir.
Interface Panel
Caution! Turn Instrument off and remove power cord
before replacing fuses. Fuses must be replaced with
the same current rating and type described next to the
fuse holder.
Heater
Caution! Heater is hot; do not touch.
Section 1
Safety Considerations
1