Haas Automation EC Series, Книга управления

Страница: 65 / 127

58
January 2004
Reverse X & Y
When this menu item is selected, all X address codes in the program will be changed to Y address codes, and
Y’s to X. If a block is selected, only the address codes contained within it will be affected.
THE I/O MENU
Send RS-232
This menu will send program(s) that are selected from the program directory to the RS-232 port. When this
menu item is selected, a list of all the programs in memory is presented, with ‘ALL’ at the end.
To select a program, cursor to the program number and press the INSERT key. A highlighted space will appear
before the program to indicate it has been selected. Pressing INSERT again will deselect the program, and the
highlighted space will disappear. The DELETE key can be used to deselect all selected programs. When the
cursor is on “ALL”, all the programs are selected regardless of highlighting
To send the selected program(s), press the ENTER key. If more than one program or ‘ALL’ is selected, the data
will be sent with one “%” at the beginning of the stream and one at the end.
Receive RS-232
This menu item will receive program(s) from the RS-232 serial port. The program(s) will then be stored in the
CNC memory with the corresponding Onnnnn program number(s).
On LIST PROG “ALL” must first be highlighted before using this menu item. The Onnnnn program numbers will
be entered automatically from the input stream data. Note, “ALL” must be selected again on the LIST PROG
screen after each file transfer.
Send Disk
This menu item will send program(s) to the disk. When this menu item is selected, a list of all the programs in
memory is presented, with ‘ALL’ at the end.
To select a program, cursor to the program number and press the INSERT key. A highlighted space will appear
before the program to indicate it has been selected. Pressing INSERT again will deselect the program, and the
highlighted space will disappear. The DELETE key can be used to deselect all selected programs. When the
cursor is on “ALL”. All programs are selected regardless of highlighting.
ENTER DISK FILENAME: Type in the desired disk filename (in standard PC DOS format) for the disk file being
sent, then press the ENTER key. If more than one program or “ALL” is selected, the data will be sent with one
“%” at the beginning of the stream and one at the end. If a filename is not entered, the controller will send each
selected file separately using the Onnnnn program number as the filename.
Receive Disk
This menu item will receive programs from the disk. The program(s) will then be stored in the CNC memory with
the corresponding Onnnnn program number(s).
ENTER DISK FILENAME: Type in the filename (in standard PC DOS format) of the disk file being received,
then press the ENTER key.
Disk Directory
This menu item will display the directory of the disk, with the first entry highlighted. To select a file, press the
up and down arrow buttons or use the jog handle. To load a file, select it and press the WRITE key. The G-code
programs in the file will be loaded into memory.
If there is insufficient memory for the entire file, Alarm 429 will be generated, and only a partial directory will be
displayed.