Haas Automation EC Series, Книга управления

Страница: 106 / 127

99
January 2004
%
N0 Vnnnnnn
N1 Vnnnnnn
N2 Vnnnnnn
.
.
%
The following table shows the use of the N numbers in the output file when offsets are saved to RS-232 or disk.
Tool length:
Tool/function length wear diameter wear
1 001 201 401 601
2 002 202 402 602
: : : : :
200 200 400 600 800
The nnn numbers for work offsets are as follows:
Offset/axis X Y Z A B
G52 801 802 803 804 805
G54 806 807 808 809 810
G55 811 812 813 814 815
: : : : : :
G59 831 832 833 834 835
G110 836 837 838 839 840
G111 841 842 843 844 845
: : : : : :
G129 931 932 933 934 935
The nnnn numbers for coolant spigot positions are as follows:
1 936
2 937
: :
200 1135
The N number is the data number and V is the value. N0 is a CRC code that is computed by the control prior to
sending the data. The N0 value is mandatory with parameters but is optional with settings and offsets. If you
make a change to some saved data value and leave the old CRC, you will get an alarm when you load that
data. With settings and offsets, you should delete the N0 line if you make changes to the saved data.
Data that is received garbled is usually converted into a comment and stored into your program while an alarm
is generated. Errors generating an alarm may also stop the receive operation.
To get a DIRECTORY LISTING , select the PRGM/LIST PROG mode, and press F4. This will generate a Disk Directory
Listing that will be saved in program 0xxxx where xxxx is defined in parameter 227. The default value is 8999.
On the List Prog page, type “DEL <filename>” where <filename> is the name of a file on the floppy disk. Press
WRITE. The message “DISK DELETE” will appear, and the file will be deleted from the floppy disk.
At the end of a save or load function, the bottom left corner of the display will show either: “DISK DONE” for normal
completion or “DISK ABORT” if any errors cause it to stop. The actual errors are listed in the ALARM display.