H3C S12500-X, Руководство по установке

Страница: 91 / 168

82
2. Remove the optical fiber from the module.
3. Pull down the metal handle on the module to the horizontal position.
4. Hold the handle to pull the module horizontally and slowly out of the port.
5. Insert the dust plug into the module and put the module into its original shipping materials.
6. Install a new CFP2 module in the port. For the installation procedure, see " Installing FRUs ."
If you are not to install a CFP2 module in the port, insert the dust plug that is provided with the LPU
into the port.
Replacing a CXP module
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "
Installing FRUs ."
2. Remove the optical fiber from the module.
3. With your forefinger, pull the module out of the port carefully.
4. Insert the dust plug into the removed module, and put the removed module into its original shipping
materials.
5. Install a new CXP module in the port. For the installation procedure, see " Installing FRUs ."
If you are not to install a CXP module in the port, insert the dust plug that is provided with the LPU
into the port.
Replacing a CXP fiber cable
CAUTION:
• Do not use excessive force to remove the cable. If the cable cannot be removed or installed, verify that
the removal or installation procedure is correct.
•
When you remove the cable connector from the port, pull the pull latch horizontally for smooth
removal and avoiding damage.
To replace a CXP fiber cable:
1. Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded.
For more information, see "
Installing FRUs ."
2. Use your forefinger to gently pull the cable connector out by its pull latch.
3. Put the removed cable into its original shipping materials.
4. Connect a new CXP fiber cable to the port.
For the connection procedure, see "
Installing FRUs ."
5. If you are not to connect a new CXP fiber cable to the port, insert the dust plug that is provided with
the LPU into the port.