GSK983Ma Milling Machine Center CNC System User Manual
34
Part 1 Programming
The feedrate is modified from a to b and c to do for the program of an arc.
②
3) Modification value
The modification value is set by the parameter #334.
1
≤
AOVOR (each gear 1%)
≤
100 (%)
It is also enabled for the dry run and the F1-digit command. In the case of the F4-digit command,
the actual feedrate is as follows:
Fx (AOVOR) × (Feedrate modification)
4) Whether the inner corner modification is enabled
The inner corner modification can be determined by the G code, in the group 15, add the G62
between the G91 and G64, refer to the following table. These G codes are related with the exact stop
check mode.
Exact stop check
Inner corner modification
G61 Enabled Disabled
G62 Disabled Enabled
G64 Disabled Disabled
Note 1: G64 state is performed when the power is turned on or off.
Note 2: G09 must be specified if the exact stop check is performed in the mode of G62.
Note 3: The inner arc cutting feedrate change is always effective which is not affected by the G codes,
refer to the Section 4.7.2.
3.4.7.2 The change of inner side arc cutting
In the case of the inner side arc offset cutting, the feedrate of programmed path is specified by
the F code, and the actual feedrate is F×R
C
/R
P
(wherein, R
C
is a radius of tool center path; R
P
is a
radius of program path).
This change is also valid to the dry run and F1-digit command.
(For example 1)
Содержание GSK983Ma
