GSK GSK983Ma, Руководство пользователя

Страница: 333 / 373

Appendix 5. Parameters
321
Appendi
x
SLOW 1: The set parameter for clamping value at the lowest spindle revolution in constant
surface control mode can be applied to all gears.
（
parameter No. 347
）
0 : sets separately to each gear
（
parameter No. 343, 344, 345, 346
）
BDEG 1: the B axis input unit is 0.001°
（
B1=0.001°
）
.
0: the B axis input unit is 1°
（
B1=1°
）
.
IDXB 1: The indexing sequence B of the index table
0: The indexing sequence A of the index table
(1) Indexing sequence A
(2) Indexing sequence B
In-position check is always performed at A point as the indexing sequence A/B is followed.
Note 1: If a reset is made in waiting state after the completion of clamping or unclamping, the
clamp or unclamp signal is cleared and the NC enters wait state.
Note 2: The clamping/unclamping state is unchanged after resetting, i.e. the sequence of
clamping or unclamping cannot be executed through resetting automatically, but the
clamping or unclamping signals is cleared.
Note 3: The waiting state after the completion of clamping or unclamping is displayed in the
diagnosis state. (Diagnosis DGN701-BCNT)
SSCR 1: In rapid traverse blocks, the surface speed is calculated according to the end point
coordinate of the current block.
0: In rapid traverse blocks, the surface speed is calculated according to the current
position of the tool.
SSCA2, SSCA1, SSCA0 set the axes as calculation basis in surface constant speed control.
SSCA2 SSCA1 SSCA0 axis
0 0 0 X
0 0 1 Y
0 1 0 Z