GSK GSK983Ma, Руководство пользователя

Страница: 229 / 373

Chapter Four Operation
217
Part 2
Operation
4.3.6.5 Single Block
When SINGLE is valid, the control unit executes only a block each time when the “Cycle Start”
key is pressed.
When the “SINGLE BLOCK” is set to 1 in the page of the menu switch setting, the control
equipment is stopped after performing one program. Press “cycle start” key, and control unit stops
after the next block is executed.
Note 1: In G28, G29 or G30 mode, tool will stop at intermediate point if single block
function is used.
Note 2: In canned cycle machining, if single block function is valid, the tool will stop on
the cycle path
① ，
or of canned cycle (see the following figure).
② ⑥
When the repeated calculation of canned cycle is not 1, execution stops each time
except for the block of final cycle, and “Feed Hold” indicator light ⑥ s up.
“Feed Hold” indicator lights up each time for the and the blocks stop. ① ②
Note 3: For blocks M98P— ， M99 ， and G65 ， G66 or G67, single block stop is invalid.
However, if commands in block M98 or M99 are the address except O, N, L and P,
single block stop is valid.
4.3.6.6 Restart after Feed Hold or Stop
（ 1 ） Select Auto mode.
（
2
）
”Feed Hold” indicator goes out when “cycle start” key is pressed.
4.3.6.7 Manual Operation in Automatic Running
（
1
）
In automatic running, running stops by pressing “feed hold” key on the panel or making “single
block” function valid
（ 2 ） Record coordinates of the stop position displayed by the position display unit.
（
3
）
Perform manual operation (see 4.3.4.3)
（ 4 ） Return tool to recorded coordinates (start point of manual operation)
（ 5 ） Restore to the previous state and mode before manual operation to restart automatic running.
（
6
）
Press cycle start key.