GSi Smart Climate 310, Руководство пользователя

Страница: 20 / 102

20 Smart Climate 310 rev. 03
Use inlet compensation in minimum ventilation mode?
Select Yes to keep using the temperature and/or SP compensation
on the inlet opening when the controller is in minimum ventilation
mode.
Inlet Follow Minimum Speed? :
Select “Yes” for the inlets’
opening in minimum ventilation to follow the changes of the
variable fans’ minimum speed.
Accessible only if one or more inlets are enabled above or if the 0-
10V output is configured as an inlet below
Reference Speed : Set the variable fan speed that will be used as
the starting point to calculate the inlet opening in minimum
ventilation (see graph on page 73).
Available only if Inlet Follow Minimum Speed is enabled above.
Use a timer on heating stages:
Select Yes for heater to run in timer mode.
Accessible if at least one heating stage is enabled above.
Zoned or standard heaters:
Zoned heaters operate according to the temperature reading made
by a group of sensor rather than using the average room
temperature as a reference.
Accessible if 2 heating stages are enabled above.
Heater probes:
Select the probes that are used to control each heating stage.
NOTE: Blinking digits represent probes that are selected to be
part of the average room temperature. At least one temperature
probe must be selected.
Accessible if zoned heaters are enabled above.
Fan De-icing:
The de-icing function allows activating the 2nd fan stage briefly
(i.e., the stage that follows the minimum ventilation stage). This de-
icing function prevents fans from freezing in winter. Select Yes to
enable this function.