Grundfos Multilift M Series, Инструкция по установке и эксплуатации

Страница: 26 / 720

English (GB)
26
Fig. 18 Untightened screw in outer ring
Fig. 19 Plugging the main inlet
3. Prepare optional inlet by cutting out the desired one.
Use cup drills
∅
150 for DN 150,
∅
100 for DN 100 and
∅
43 for
DN 50 inlets. The cutting line is recessed. To avoid sharp
cutting edges, the hole must be deburred. The socket seals
are provided with collars.
4. Prepare the connection for diaphragm pump (optional).
Use cup drill,
∅
43, for DN 50 connection socket. To avoid
sharp cutting edges, the hole must be deburred.
Fig. 20 Cutting or drilling of optional connection holes
5. Connect the inlet pipe to the tank.
Install an isolating valve between inlet pipe and lifting station
to avoid inflow during maintenance and service.
We recommend an easy-to-handle PVC isolating valve.
Fig. 21 Installation of isolating valve
T
M
05
03
3
6
10
11
Caution
Multilift M lifting stations are supplied with loose
screws in the outer ring of the turnable inlet disk.
See fig. 18. Check and tighten all screws to max.
tightening torque of 9 Nm before connecting the
inlet pipe.
Note
If the main inlet is not to be used, it can easily be
plugged using a standard DN 100 pipe plug
fastened with three screws and washers.
See fig. 19.
Only the screws and washers are supplied with
the lifting station. The pipe plug must be bought
separately.
TM
05 03
29 10
11
-
TM
05 03
52 101
1
TM
05
12
42
25
11
TM
05
1
503
28
11
Caution
Make sure that weight from inlet, discharge and
vent pipes does not rest on the tank. Long pipe
sections, valves, etc. must be supported.
Warning
Never step on the lifting station.
DN 50 -
∅
43
DN 100 -
∅
100
DN 150 -
∅
150