GREMO 1050F4, Инструкция по эксплуатации, Страница: 135 / 198

Gremo1050F4 Instruction manual 6 Driving instructions
6.16 Off-road operation
6.16.5 Spacer blocks
Fig. 108 Bogie stop band,
installation instructions
When bogie tracks are used, you should also fit the spacer
blocks which restrict the up and down movements of the
bogie. The spacer blocks (1) and Allen bolts M12 x 80 (2)
have been delivered with the machine.
Do as follows:
• Align the spacer blocks correctly: the wide end of the
spacer block should point forwards for the frontal block
(3) and rearwards for the rear block (4).
• The chamfer of the spacer block (5) must be next to the
weld (6).
• Fit the Allen bolts and tighten them with a 10 mm Allen
key (7).
6.16.6 Driving speed
The machine is designed to cope with a maximum payload
even on very difficult ground. Off-road driving causes large
dynamic forces on the machine. This means that the
weight of the machine together with the weight of the
payload will increase as a result of the movements. The
dynamic forces may cause considerable impact on the
machine frame and the articulated joint, e.g. when the
machine moves over an obstacle.
You can avoid this by driving gently and with sound
judgement. To drive fast is one thing, to keep the right
speed is a different one!
When driving with a payload the crane should be put down
on the load and the grapple should be secured. This way
you lower the centre of gravity, and spares the rotator and
the vibration damper. When driving with an empty machine
we recommend that the grapple is placed down at the front
bunk.
131