Gregoire Besson SP9 COMPACT, Инструкция по эксплуатации и техническому обслуживанию

Страница: 99 / 108

Operation manual SP 9 - Compact
CHAPTER XI - GREASING AND MAINTENANCE –- Page 1
3
11.6. THE PREPARATION OF THE PLOUGH FOR PLACING IN THE MACHINE-
SHED
Before storage the plough at the end of the season
1. Clean the plough from dirt and plant residues as they keep the moisture and may
cause rust.
2. If the plough is dry lubricate every axle-journal to clear it from water and other
impurities.
3. If it is necessary correct the painting. The GRÉGOIRE-BESSON red paint can be got
in the form of spray from the brand dealer.
4. Check if there are used or broken spare parts. If it is necessary change them.
5. Check if there are disengaged bolts. Fasten them or change them.
6. Check if there is too big lash of the axle-journal. If it is so then fasten them or change
the wear-rings inside.
7. It is more reasonable to perform reparation immediately at the end of the plough
season in order not to forget about them later. Do not delay the maintenance till the
beginning of the plough season.
Protect the spare parts which are used for the work in the soil
Protect from corrosion the breasts of the plough and jointer and blades by putting on them
the suitable thickness of the oil or graphite coat. A thin paint coat can be put as well but it
is easily can be removed during the next ploughing.
Protect the rods of the cylinders which can not be pulled back.
The rust formed on the cylinders can damage their joining. If a push-rod can not be pulled
back totally cover it with thin grease or oil coat (Shell ENSIS – SX type).
11.7. PRECAUTIONS DURING THE PLACING IN THE MACHINE-SHED
¾
Before disengaging the plough, be sure that the
storage surface is plane, clean and stable,
¾
Use blocking implements to prevent from the
plough moving during or after the disengaging,
¾
Stabilize the plough wheels,
¾
NEVER leave the machine in the turning up
position,
¾
Neutralize the pressure in the hydraulic circuits with the moving the directing levers
placed in the cabin from forward back after the tractor engine has been stopped.
¾
The plough should be placed far from any actions.
¾
The plough should be put in the dry, dust-proof place (if it is possible in the building), with
pulled in cylinder rods in order to avoid rust,
¾
Some wheel can revolve free, so never lean against them, do not put anything on them
that may fall.
ATTENTION: Do not allow children to play on or near the plough either during the
storage or engagement to the tractor.